Find Your Australia Skilled Occupation List

Solid Plasterer - 333212

Description

Solid Plasterers apply decorative and protective coverings of plaster, cement and similar materials to the interiors and exteriors of structures.

Skill Level

3

Skills Assessment Requirements

Unless you are exempt in very limited circumstances, you are required to have a positive Skills Assessment to apply for the visas listed above.

Skills Assessment authority for Solid Plasterers is Trades Recognition Australia (TRA). To have a positive skills assessment, you must meet the following criteria:

  • Must have successfully completed an AQF Qualification either a Certificate III in Solid Plastering or formal training that is comparable
  • Must possess skills that are current to Australian industry standards demonstrated by 12 months full time employment or equivalent part-time in the occupation in the previous three years
  • If you have obtained a qualification internationally or an Australian qualification that was not through the Australian Recognition of Learning process, you are required to demonstrate 3 years full time or equivalent post-qualification experience
  • If you have obtained an Australian qualification issued through the Australian Recognition of Learning process, you are required to demonstrate 3 years full-time or equivalent post-qualification experience OR 6 years full-time or equivalent experience which can be either pre- or post-qualification
Group Title 3332 Plasterers
Group Description

Apply and fix plasterboard partitions, suspended ceilings, fire rating systems, acoustic tiles, and composite wall linings to buildings, and apply decorative and protective coverings of plaster, cement and similar materials to the interiors and exteriors of structures.

Tasks

  • Determining plasterboard layout, and installing insulation and vapour barriers
  • Measuring, marking and cutting plasterboard, lifting and positioning panels, and securing them to walls, ceilings and battens
  • Preparing corner beads and securing them in position
  • Fixing pre-cast cornices, panel mouldings, ceiling centres and other plaster fittings
  • Covering joins and nail holes with wet plaster and sealing compounds, and smoothing them using wet brushes and sand paper
  • Mixing and applying coats of plaster, cement and render to structures using trowels, and levelling and smoothing coats to uniform thickness
  • Plumbing and straightening corners, angles and wall and ceiling surfaces
  • Creating decorative textures in finishing coats
  • Applying and finishing acoustic, insulating and fireproofing materials bonded with plaster, plastic cement and similar materials

Skill Level

Most occupations in this unit group have a level of skill commensurate with the qualifications and experience outlined below.
In Australia:
AQF Certificate III including at least two years of on-the-job training, or AQF Certificate IV (ANZSCO Skill Level 3)

In New Zealand:
NZ Register Level 4 qualification (ANZSCO Skill Level 3)

At least three years of relevant experience may substitute for the formal qualifications listed above. In some instances relevant experience and/or on-the-job training may be required in addition to the formal qualification.
Registration or licensing may be required.

Occupations in this Group

  • 333211 Fibrous Plasterer
  • 333212 Solid Plasterer

How to calculate your points (skilled visas)

To apply for a skilled visa, you must determine your points score. The minimum required to be eligible is 65 points. However, depending on your occupation, the demand, and the state you are applying to, you may need a higher score to receive an invitation.

Back to Skilled Occupation List

Check your Australia PR Points in 60 Sec

Here’s how we can assist you:

  • Initial Consultation
  • Visa Application Guidance
  • Information Confidentiality
  • Face-To-Face Guidance
  • Document Preparation
  • Application Submission
  • High Success Rate
  • No Hidden Charges
  • Online and Offline Support
  • Specialized Assistance
  • Final Review and Follow-Up
  • Zero Defect

Why Choose Us?

CICC Registered MARA Registered
Hand Holding Support End-To-End Support
True & Transparent Job Search Assistance
Process Time 9-12 Months Process Time 8 -10 Months

We Provide Services that matters to our clients and beneficial for them:

  • We Have High Success Rate
  • We Provide Job Search Assistance
  • We Provide Personalized Assistance
  • We Provide Dedicated Case Manager
  • We Provide Document Preparation Assistance
  • We Provide Application Tracking Updates

Our Popular Visa

Trusted Our Partner Logo

Subscribe SVG

Call

Consultation SVG

Get in Touch