Metal Machinist (First Class) sets up and operates machine tools to shape and form metal stock and castings to fine tolerances, using details drawings and specifications.

Skill Level

3

Specialisations

• Aircraft Machinist
• Automotive Machinist
• Metal Machine Setter
• Metal Turner
• Milling Machinist
• Vertical Borer

Unless you are exempt in very limited circumstances, you are required to have a positive Skills Assessment to apply for the visas listed above.

Skills Assessment authority for Metal Machinist (First Class) is Trades Recognition Australia (TRA). To have a positive skills assessment, you must meet the following criteria:

• Must have successfully completed an AQF Qualification either a Certificate III in Engineering – Mechanical Trade or formal training that is comparable
• Must possess skills that are current to Australian industry standards demonstrated by 12 months full time employment or equivalent part-time in the occupation in the previous three years
• If you have obtained a qualification internationally or an Australian qualification that was not through the Australian Recognition of Learning process, you are required to demonstrate 3 years full time or equivalent post-qualification experience
• If you have obtained an Australian qualification issued through the Australian Recognition of Learning process, you are required to demonstrate 3 years full-time or equivalent post-qualification experience OR 6 years full-time or equivalent experience which can be either pre- or post-qualification

Fit and assemble fabricated metal parts into products, set up machining tools, production machines and textile machines, and operate machining tools and machines to shape metal stock and castings.

Tasks

• Studying drawings and specifications to determine suitable material, method and sequence of operations, and machine settings
• Fitting fabricated metal parts into products and assembling metal parts and subassemblies to produce machines and equipment
• Checking fabricated and assembled metal parts for accuracy, clearance and fit using precision measuring instruments
• Setting guides, stops and other controls on machining tools, setting up prescribed cutting and shaping tools and dies in machines and presses, and setting controls for textile machines
• Forming metal stock and castings to fine tolerances using machining tools to press, cut, grind, plane, bore and drill metal
• Cutting, threading, bending and installing hydraulic and pneumatic pipes and lines
• Preparing pattern mechanisms to control the operation of textile machines used to spin, weave, knit, sew and tuft fabric
• Diagnosing faults and performing operational maintenance of machines, and overhauling and repairing mechanical parts and fluid power equipment
• May erect machines and equipment on-site

Skill Level

Most occupations in this unit group have a level of skill commensurate with the qualifications and experience outlined below.
In Australia:
AQF Certificate III including at least two years of on-the-job training, or AQF Certificate IV (ANZSCO Skill Level 3)In New Zealand:
NZ Register Level 4 qualification (ANZSCO Skill Level 3)

At least three years of relevant experience may substitute for the formal qualifications listed above. In some instances relevant experience and/or on-the-job training may be required in addition to the formal qualification.

Occupations in this Group

• 323211 Fitter (General)
• 323212 Fitter and Turner
• 323213 Fitter-Welder
• 323214 Metal Machinist (First Class)
• 323215 Textile, Clothing and Footwear Mechanic
• 323299 Metal Fitters and Machinists nec